I believe everyone knows that after we have completed the purchase of Vickers vane pumps, we need to connect valve pipes to Vickers vane pumps, etc., then we should pay attention to Vickers vane pumps and connected valve pipes What time? What is the connection method? A. Clip connection Common valve connection methods include: flange connection, clip connection, butt welding connection,...

What are the main points that you need to pay attention and pay attention to when the vane pump is being managed? In addition to the need to prevent dry rotation and overload, prevent inhalation of air and excessive vacuum, what else? 1. If the pump steering changes, the suction and discharge directions also change. The vane pump has a prescribed steering, and no reverse is allowed. Because the...

The main characteristics of high-speed hydraulic motors are: high rotational speed, small moment of inertia, easy starting and braking, and high sensitivity of speed regulation and reversing. Usually, the output torque of high-speed hydraulic motors is small, only a few tens to several hundred N × m, so it is also called high-speed low-torque hydraulic motors. High-speed hydraulic motors...

The concept of the gear pump is very simple, that is, the fundamental way of the gear pump is that two gears of the same size mesh with each other and rotate in a tightly matched housing. The inside of this housing is similar to the "8" shape, and the two gears are installed inside. , The outer diameter and both sides of the gear are closely matched with the shell. The material from the...

How to solve the problem of oil leakage caused by unreasonable design of Vickers vane pump piping pattern? What are the solution methods in the solution process? When the Vickers vane pump piping layout design is not reasonable, the oil leakage directly affects the oil leakage at the pipe joint. Statistics show that 30%-40% of oil leakage in Vickers vane pump system comes from unreasonable...

Although the structure of YUKEN vane pump is quite different, there are many similarities in installation and use. Notes on hydraulic pump connection. 1. The hydraulic pump can be installed with support or flange. The pump and prime mover shall adopt common foundation support. The flange and foundation shall have sufficient rigidity. Special attention should be paid to the plunger pump with a...

Servo energy-saving hydraulic station is a more complex hydraulic control mode, and it is also a closed-loop control. Its application is relatively extensive at present, especially in the field of industrial control. However, it also has corresponding advantages and disadvantages, so let's talk about it in detail. The servo energy-saving hydraulic station has the following advantages: (1) The...

Today we will talk about the main measures for the use and maintenance of servo vane pump. 1. Plunger pump has large flow rate, high pressure, high rotating speed and poor operating environment, especially large temperature difference. Hydraulic oil must be strictly selected according to the requirements of the manufacturer. Low-grade hydraulic oil must never be used. It is more prudent to...

Hydraulic vane pumps are divided into gear pump, vane pump and plunger pump. 1.Gear Pump Advantages: smaller volume, simpler structure, lax requirement on cleanliness of oil and lower price. Disadvantages: The pump shaft suffers from unbalanced force, serious wear and large leakage. 2.Vane Pump Advantages: It is divided into double-acting vane pump and single-acting vane pump. This kind of pump...

Servo vane pump gloally first created, High pressure and high performance dowel pin type vane pumps are widely used for plastic machinery, casting machinery. With dowel pin vane structure, it can work in high pressure, low noise and long lifetime. Now let's introduce some points for attention about servo vane pump. 1. Considering from the aspect of servo pump, since its pressure will change, it...