Corrugated Plastic Box Wholesaler describes how to clean the hollow board turnover box:

In daily use, the hollow board turnover box will definitely encounter the problem of poor cleaning, but if the correct use and operation methods are followed, not only can the service life be extended, but also the company's procurement cost can be reduced. So how to clean and maintain the hollow board turnover box?

In fact, the hollow board turnover box is very simple to clean. As long as you use the container for cleaning agent, latex gloves, rags and brushes, it is cleaned in the general production area. The order of cleaning is to clean the corners and then the plane. , From the inside to the outside, from the top to the bottom, so that the clean hollow board turnover box is very clean.

Put the clean and clean hollow board turnover box outdoors to dry naturally, and then the product can be packaged and shipped with the car, and its performance will not be affected.

Since our commonly used hollow board turnover box is made of hollow plates, and the hollow board manufacturer can customize the turnover box according to the size, drawing, and characteristics provided by the customer. It has high flexural resistance, high load-bearing strength, and shock absorption and can be Push-to-stack, lightweight and durable, it is used in the packaging of finished products during the transportation of the product.

It can effectively protect the quality of products, increase the qualified rate of products, reduce costs for customers, and let customers rest assured to use hollow board boxes. Regarding the daily maintenance of the hollow board turnover box, the main points are as follows:

  1. When not in use, the hollow board turnover box should be neatly stacked on the flat ground.
  2. When stacking and storing, the four corners of the upper turnover box should be stacked in parallel with the four corners of the lower turnover box, and the bottom of the lower turnover box should be flat in contact with the ground. If it is not stacked in parallel, it will take one time. The long is likely to cause deformation or bending of the turnover box.

Through the above introduction, China Corrugated Plastic Partitions Manufacturers hopes that you can simply refer to the content of this article in future use.