The relevant introduction of the Injection Pump Machine is as follows:
Pulsation-free delivery: uniform motion throughout the entire process, smooth work without pulsation. Wide operating speed: 10,000 times the wide operating speed range greatly increases the flexibility of the user. No need to clean: to transport fluids with different characteristics, just replace the syringe. Accurate flow: high control accuracy , When ≥30% of full stroke, control error ≤±0.5%
- There are more than 300 types of syringe pumps
- The injection pump is divided into an electric injection pump and a propulsion injection pump
- The electric injection pump is divided into single channel, dual channel, and programmable ten channels, which can be selected according to your requirements
- A variety of syringes are available, and the syringes can be automatically identified
- The minimum flow rate can be set at 0.001 microliters/hour, the flow rate is 0.001 microliters/hour, the accuracy is ±0.5%, the repeatability is ±0.2%, and the operating speed of the electric injection pump is 9.5*10mm/min
- Programmable syringe pump can freely set the flow rate of 2 or 10 syringes, and different flow rates can be set separately
- With voltage and current signal output, with RS232 interface, can be connected to printer and computer, and can be connected to time controller
- The syringe pump can choose to run in both directions, it can inject liquid in one direction, or it can recycle the injection to achieve mixing.
- Pulse can be set to prevent too much impact on small animals during feeding and irrigation
- Optional foot switch for easy operation
- The push-type injection pump can be set to the number of advances (from 1 to 19,000 advances), and can choose to operate in two directions, which can either inject liquid in one direction or recycle the injection to achieve mixing.
- You can choose up to 4 simultaneous pushers (the needles connected to the pushers have more than 200 specifications, and the injection volume and distance of each syringe can be set freely. The minimum distribution amount is 0.0526 microliters per injection. , The moving distance is 3.2 microns, the fastest speed can reach 700 injections in 1 second, RS232 signal output, can be connected to a foot switch and a computer)